J&N Starter Motor (410-54238) BRAND_RAM Mounts Used for removal of the

Used for removal of the flywheel or rotor if applicable

not hard plastic

triple clamp hardware

Quality design and construction of every All Balls piece meets the toughest standards and conditions — from daily commuting to full-on racing

Outside Length: 279mm

J&N Starter Motor (410-54238) BRAND_RAM Mounts Used for removal of theQuality replacement Starter Motors Note: Brush kid AHSMU9114 will fit this starter motor. Please Note: All electrical components must be fitted by a qualified technician. Before fitting electrical components ensure the root cause of the original failure has been addressed. The absence of either of points 1 or 2 above, will void any warranty.