Cross Right Corner Decline and Incline (30-45 degrees) for 48mm Galv Pipe img2 often used where top rail

often used where top rail meets corner upright on level sites

If you prefer to stain and lacquer the dowel

What are the important dimensions

A domestic quality 16mm drill bit

Apply wood glue at the join and lightly sand to blend

Cross Right Corner Decline and Incline (30-45 degrees) for 48mm Galv Pipe img2 often used where top railWhere would you normally use this galvanised pipe fitting ? The 286 is a 90 degree corner joint, often used on middle rail on angled sites and often paired with type 128. This fitting cannot be used where through tube (vertical in photo) has to be joined within the fitting. What size pipe does it fit to ? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 48mm. What is it made out of ? All of the pipe fittings